[meencegic]

Trying to get something to work via this device: EASY512-AC-RC

I have 4 inputs i want to use:

1. Uneven lights (the uneven row of lights)
2. Even lights
3. Doorcontacts (from the overhead doors)
4. Alarm (from the alarm system)

The 2 light inputs will be used as a puls input.
Doorcontact and Alarm will hold (As long as door is open and as long as alarm is going off)

The 500 series has no OR, AND gates and just virtual relays which i can can give the following settings:

• normal (follows the input)
• toggle
• set (will set the relays, until a reset is given, note that a reset wont work if the set is still powered)
• reset (tied to the set of the same virtual relays)
• inverse (like it says)

In the software i can use the virtual relays contacts as normal or inversed.

What i want todo:

• Use input 1 and 2 for the lights in the hall, uneven and even rows.
• input 3 (doorcontact) will switch on the uneven rows, but must be able to turn off using input 1 (uneven rows)
• input 4 (alarm) will switch on all lights regardless of light status.

Any ideas where to start? been tinkering around but atm brain is blank [help]